pro/detail
pro/detail
(OP)
I have been trying to setup a floating license on the network to use the single floating pro/mechanica license that we have.
STEP 1: I first put the license.txt file that contains the mechanica license in a network folder.
STEP 2: I then inserted the ptc cd and did an install of just pro/mechanica:
I get to the following step where Pro/E asks me:
"Please indicate all license servers that you wish to use with this installation of Pro/ENGINEER Mechanica"
I direct it to the license.txt file that I placed in the network folder in STEP 1.
STEP 3: I then reran the prosetup.bat file that is in the bin folder
(C:\Program Files\proeWildfire 3.0\bin)
However whenever I try to run mechanica It says that it is
"Unable to get required license."
STEP 1: I first put the license.txt file that contains the mechanica license in a network folder.
STEP 2: I then inserted the ptc cd and did an install of just pro/mechanica:
I get to the following step where Pro/E asks me:
"Please indicate all license servers that you wish to use with this installation of Pro/ENGINEER Mechanica"
I direct it to the license.txt file that I placed in the network folder in STEP 1.
STEP 3: I then reran the prosetup.bat file that is in the bin folder
(C:\Program Files\proeWildfire 3.0\bin)
However whenever I try to run mechanica It says that it is
"Unable to get required license."





RE: pro/detail
The reason is that the license file is useless without installing & running a License Server.
RE: pro/detail
It does seem the robertib is correct. The licence server is either not running or has not been installed.
Put the CD in and run the setup again and install the licence server.
If it is installed and is not running, it can be started in the services area of windows.
Adrian