I Get It / Unigraphics NX Training
I Get It / Unigraphics NX Training
(OP)
I have exhausted the entire CAST training that NX comes with and before I go train at the UGS site I wanted to pick up some additional training on my own. I came across the "I get It" website and they provide an "NX Training Bundle" has anyone used it and how does it different from the NX CAST? I'm more intrested in the Manufacturing/Milling training.





RE: I Get It / Unigraphics NX Training
jjoyce@myigetit.com
John Joyce
Tata Technologies iKS
1675 Larimer St.
Denver, CO
www.myigetit.com
RE: I Get It / Unigraphics NX Training
Although I must say v4 was a lot more user friendly than the current (cluttered) v5.
Specialty Engineered Automation (SEA)
http://www.sea4ug.com
a UGS Foundation Partner
RE: I Get It / Unigraphics NX Training
John Joyce
Tata Technologies iKS
1675 Larimer St.
Denver, CO
www.myigetit.com
RE: I Get It / Unigraphics NX Training
John Joyce
Tata Technologies iKS
1675 Larimer St.
Denver, CO
www.myigetit.com
RE: I Get It / Unigraphics NX Training
RE: I Get It / Unigraphics NX Training
Yes I do, but I also use it to learn Solid Edge, Solid Works and yes even Pro/e
John Joyce
Tata Technologies iKS
1675 Larimer St.
Denver, CO
www.myigetit.com
RE: I Get It / Unigraphics NX Training