Creating a square corner for a title block
Creating a square corner for a title block
(OP)
I was wondering if someone could please help me create a "square" corner for my title block.
I am using a 0.7mm border and the corners of my border appear stepped.
I know in the line font properties that the "end cap style" can be set to flat, square or rounded... however, that doesn't seem to apply when editing a sheet format.
I am using SW2007 ... any help most appreciated. Thanks.
I am using a 0.7mm border and the corners of my border appear stepped.
I know in the line font properties that the "end cap style" can be set to flat, square or rounded... however, that doesn't seem to apply when editing a sheet format.
I am using SW2007 ... any help most appreciated. Thanks.






RE: Creating a square corner for a title block
Got it sorted when I changed the end cap style for "sketch curves" to "square".