×
INTELLIGENT WORK FORUMS
FOR ENGINEERING PROFESSIONALS

Log In

Come Join Us!

Are you an
Engineering professional?
Join Eng-Tips Forums!
  • Talk With Other Members
  • Be Notified Of Responses
    To Your Posts
  • Keyword Search
  • One-Click Access To Your
    Favorite Forums
  • Automated Signatures
    On Your Posts
  • Best Of All, It's Free!
  • Students Click Here

*Eng-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail.

Posting Guidelines

Promoting, selling, recruiting, coursework and thesis posting is forbidden.

Students Click Here

Jobs

Wire EDM NX4

Wire EDM NX4

Wire EDM NX4

(OP)
What is the correct way to select a wireframe geometry with multiple members [lower] as boundary for wire EDM using UGS-NX4. I get always the error message "missing side lines". I can select up to 2 members without any message.

Thanks in advance , Bert

RE: Wire EDM NX4

The top and bottom boundary segments need to be connected.
Add lines between the segments at each end point.
I think you need the same number of segments for the top and bottom boundaries.   

John Joyce
Tata Technologies iKS
1675 Larimer St.
Denver, CO
www.myigetit.com

Red Flag This Post

Please let us know here why this post is inappropriate. Reasons such as off-topic, duplicates, flames, illegal, vulgar, or students posting their homework.

Red Flag Submitted

Thank you for helping keep Eng-Tips Forums free from inappropriate posts.
The Eng-Tips staff will check this out and take appropriate action.

Reply To This Thread

Posting in the Eng-Tips forums is a member-only feature.

Click Here to join Eng-Tips and talk with other members!


Resources