Making a cone sheetmetal part??
Making a cone sheetmetal part??
(OP)
I've searched other threads on this subject and found one that was useful but I've tried doing it the way that TheTick had outlined in thread 559-199521. I create a revolve of my cone and only revolved it 358 degrees but when I go to insert bends I keep getting an error.
Can anyone help me out. Thanks.
Can anyone help me out. Thanks.






RE: Making a cone sheetmetal part??
Are you selecting a straight edge when prompted?
RE: Making a cone sheetmetal part??
Jeff Mirisola, CSWP, Certified DriveWorks AE
http://designsmarter.typepad.com/jeffs_blog
Dell M90, Core2 Duo, 4GB RAM, Nvidia 3500M
RE: Making a cone sheetmetal part??
Give me the dunce cap and set me in the corner!!
Thanks for the reply CorBlimeyLimey.
RE: Making a cone sheetmetal part??
RE: Making a cone sheetmetal part??
Jeff Mirisola, CSWP, Certified DriveWorks AE
http://designsmarter.typepad.com/jeffs_blog
Dell M90, Core2 Duo, 4GB RAM, Nvidia 3500M