Curve selection
Curve selection
(OP)
Prior to NX5 I was able to select only specific curves in a sketch (instead of the whole sketch) by setting my filter to "curves" and selecting only the curves that I want to extrude.
I now have that new pull-down filter set to "curves" but it always selects the entire sketch in the extrude that I want to do. "Sketch" is an available option on that filter, and it is not selected.
It is really not the end of the world if I need to break down the sketch, into a few individual sketches, but I would rather not.
Any suggestions on something that I will need to toggle to make this work?
I now have that new pull-down filter set to "curves" but it always selects the entire sketch in the extrude that I want to do. "Sketch" is an available option on that filter, and it is not selected.
It is really not the end of the world if I need to break down the sketch, into a few individual sketches, but I would rather not.
Any suggestions on something that I will need to toggle to make this work?





RE: Curve selection
RE: Curve selection
John R. Baker, P.E.
Product 'Evangelist'
NX Design
Siemens PLM Software Inc.
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/