How to make a half section?
How to make a half section?
(OP)
Hopefully I'm just ignorant, but I can't for the life of me figure out a way to produce a half section in Solidworks? My end goal is to get an isometric half-sectioned view of a lathe'd piece -- for example, like htt p://www.tp ub.com/con tent/draft sman/14276 /img/14276 _182_1.jpg ... but I can only seem to get a full section. Could someone please screw my head on straight?
Thanks!
-Kyle
Thanks!
-Kyle






RE: How to make a half section?
I think that is some kind of solution
RE: How to make a half section?
RE: How to make a half section?
Is it possible in SW2008? I can not find that solution in SW2007.
RE: How to make a half section?
RE: How to make a half section?
RE: How to make a half section?
Thanks!
-Kyle
RE: How to make a half section?
Creating a section line as shown in combination with the RMB > Isometric section View will produce the views on the LH side.
RE: How to make a half section?
Dan
www.eltronresearch.com
RE: How to make a half section?
Matt Lorono
CAD Engineer/ECN Analyst
Silicon Valley, CA
Lorono's SolidWorks Resources
Co-moderator of Solidworks Yahoo! Group
and Mechnical.Engineering Yahoo! Group
RE: How to make a half section?
RE: How to make a half section?