NX3 Plotter help
NX3 Plotter help
(OP)
I am in need of help seting up my plotter. I have gone through and set up the printer, along with the paper sizes, alignment, etc. When I try to plot the top 1/4 inch of drawing is being cut off. I have my settings with no margins, and set up to print to an 11x17" page, and best fit to page. Also, my sheet size is 10.85" x 17", and my title block is 10.82 x 16.711. Any suggestios on how to get this to print the entire image? Thanks





RE: NX3 Plotter help
Hope this helps,
Rick
RE: NX3 Plotter help
That worked along with playing arounw with the shifting in the vertical and horizontal a little bit.