SPLIT LINE
SPLIT LINE
(OP)
Hi all,
Have a multi tapered surface revolution describing minor diameter of thread. Have another surface sweep describing thread pitch. I was hoping to use split line-intersection to generate the muti tapered helix I could use to sweep a thread profile into a body. Sweep of thread profile will not allow selection of the generated split line however. Any thoughts?
Also can someone send me a link to sit search instructions. I seem to have a hard time finding info. Thanks
Have a multi tapered surface revolution describing minor diameter of thread. Have another surface sweep describing thread pitch. I was hoping to use split line-intersection to generate the muti tapered helix I could use to sweep a thread profile into a body. Sweep of thread profile will not allow selection of the generated split line however. Any thoughts?
Also can someone send me a link to sit search instructions. I seem to have a hard time finding info. Thanks






RE: SPLIT LINE
Dan
www.eltronresearch.com