NX 5 Toolbar Customization
NX 5 Toolbar Customization
(OP)
I am setting up custom tool bars for NX5. I currenly have a toolbar drop down that runs different macros to place specific rev blocks and flags on the drawing. For now these different rev blocks and flags are identified by a specific bitmap. These bitmaps are very hard to read at the smaller toolbar sizes. Is there a way to change from the bitmaps and just have a list of text drop down and be selected similiar to the menus?
Thanks!
Thanks!





RE: NX 5 Toolbar Customization
John R. Baker, P.E.
Product 'Evangelist'
NX Design
Siemens PLM Software Inc.
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
RE: NX 5 Toolbar Customization
-Dave Tolsma
Tolsnet LLC
http://groups.google.com/group/NX_CAX/
http://groups.google.com/group/plm-exchange/