Duplicate Datum Creation Warning
Duplicate Datum Creation Warning
(OP)
In NX4 I am not getting the warning when I create a duplicate datum. For example, if I create a datum by selecting a face and give offset of 10" and again try to create similar datum (offset of 10" from same face), I used to get warning in NX2 which was very useful. Why I am not getting it in NX4? or am I missing some setting?





RE: Duplicate Datum Creation Warning
Do you have any idea why this warning message is removed in later versions?
RE: Duplicate Datum Creation Warning
John R. Baker, P.E.
Product 'Evangelist'
NX Design
Siemens PLM Software Inc.
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/