fatal error after save part in NX5
fatal error after save part in NX5
(OP)
i am getting a fatal error and lose my nx5 session after save part. i am running on a 64 bit platform (ibm intellistation)with 8 gb of ram. this machine was originally used to run catia.i have thought it might be the graphics card (quadro fx5500) but i'm sure it has the latest driver. i also thought it might be the space pilot as it seemed it would crash when i went back to do more work. any suggestions??
Scott Copeland
Mould Designer
G-Mag International Inc
www.g-mag.ca





RE: fatal error after save part in NX5
John R. Baker, P.E.
Product 'Evangelist'
NX Design
Siemens PLM Software Inc.
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
RE: fatal error after save part in NX5
thanks for you reply
Scott Copeland
Mould Designer
G-Mag International Inc
www.g-mag.ca
RE: fatal error after save part in NX5
John R. Baker, P.E.
Product 'Evangelist'
NX Design
Siemens PLM Software Inc.
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
RE: fatal error after save part in NX5
Scott Copeland
Mould Designer
G-Mag International Inc
www.g-mag.ca
RE: fatal error after save part in NX5
John R. Baker, P.E.
Product 'Evangelist'
NX Design
Siemens PLM Software Inc.
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
RE: fatal error after save part in NX5
i have turned this feature off now and have not had this problem for some time now.
Scott Copeland
Mould Designer
G-Mag International Inc
www.g-mag.ca