Variable Table Help
Variable Table Help
(OP)
Hi,
After reading this thread - http://www .eng-tips. com/viewth read.cfm?q id=211736& amp;page=1 it got me thinking about something that I could apply to my model. It should be easy, but I think I've still got jetlag and my brain is not working properly :(
So here goes...
I have a circular cutout who's diameter is based on the value of another value in the part. I'd like to be able to suppress/unsuppress the cutout using say 1/0 from within the variable table... is this possible?
Cheers,
M
After reading this thread - http://www
So here goes...
I have a circular cutout who's diameter is based on the value of another value in the part. I'd like to be able to suppress/unsuppress the cutout using say 1/0 from within the variable table... is this possible?
Cheers,
M





RE: Variable Table Help
RE: Variable Table Help
M