Solid reference set in customer defaults
Solid reference set in customer defaults
(OP)
Hi,
I wonder if you could help me with the following problem.
I have set the customer defaults, as you can see on the attached picture, but no reference set called SOLID is created. Does anyone know why?? I am using NX 4.04
Thanks
Vit
I wonder if you could help me with the following problem.
I have set the customer defaults, as you can see on the attached picture, but no reference set called SOLID is created. Does anyone know why?? I am using NX 4.04
Thanks
Vit





RE: Solid reference set in customer defaults
The only thing to note is that UNTIL you actually create a Solid body, there will be NO 'Model' or 'Lightweight' Reference Sets created.
John R. Baker, P.E.
Product 'Evangelist'
NX Design
Siemens PLM Software Inc.
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
RE: Solid reference set in customer defaults
RE: Solid reference set in customer defaults
John R. Baker, P.E.
Product 'Evangelist'
NX Design
Siemens PLM Software Inc.
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/