assembly
assembly
(OP)
Hi,
is it possible, when working in assembly to use faces from the components as a reference to create datums, axis etc?
I cant select them and I think, it would be quite useful.
I am using NX4
Thanks
Vit
is it possible, when working in assembly to use faces from the components as a reference to create datums, axis etc?
I cant select them and I think, it would be quite useful.
I am using NX4
Thanks
Vit





RE: assembly
RE: assembly
RE: assembly
RE: assembly
Avoid doing these things as an easy way out if you can, maintaining wave geometry links is taken far too lightly by many users and regularly creates hassles downstream. I can attest that some of the most difficult modeling glitches that I have needed to fix came as a result of dodgy wave links.
Best Regards
Hudson
RE: assembly
This is all about to change.
John R. Baker, P.E.
Product 'Evangelist'
NX Design
Siemens PLM Software Inc.
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/