changing center marks
changing center marks
(OP)
I have a "D" shaped plate with a center mark locating the center. Due to room limitations remaining on the drawing, one of extension lines of the center mark runs off the edge of the drawing and is really of no use for dimensioning or anything else. Is there a way to hide one extension line of a center mark? I can grab the end and make it longer but cannot make it shorter.
thanks in advance .... RacingD98
thanks in advance .... RacingD98






RE: changing center marks
RE: changing center marks
Jeff Mirisola, CSWP
Certified DriveWorks AE
http://designsmarter.typepad.com/jeffs_blog
Dell M90, Core2 Duo
4GB RAM
Nvidia 3500M
RE: changing center marks
Chris
SolidWorks/PDMWorks 08 2.0
AutoCAD 06/08
ctopher's home (updated 10-07-07)