Solidworks 2008 Routing Manual! HELP!
Solidworks 2008 Routing Manual! HELP!
(OP)
Hi All
Please has anybody used this 2008 Routing Manual? Is this the best source material for learning Routing in SW? I am about to buy it for about $120 (reseller in UK price), but not sure if I am wasting money. I can also get the 2006 version for chump change in the USA so any advice about whether manual has been revamped much for 2008 would be greatly appreciated.
BTW: Would it be accurate to say that these Training manuals do not change much from year to year. This is what I am seeing from 2005 to 2007.
Thanks
Please has anybody used this 2008 Routing Manual? Is this the best source material for learning Routing in SW? I am about to buy it for about $120 (reseller in UK price), but not sure if I am wasting money. I can also get the 2006 version for chump change in the USA so any advice about whether manual has been revamped much for 2008 would be greatly appreciated.
BTW: Would it be accurate to say that these Training manuals do not change much from year to year. This is what I am seeing from 2005 to 2007.
Thanks






RE: Solidworks 2008 Routing Manual! HELP!
RE: Solidworks 2008 Routing Manual! HELP!
RE: Solidworks 2008 Routing Manual! HELP!
Dan
www.eltronresearch.com
RE: Solidworks 2008 Routing Manual! HELP!
RE: Solidworks 2008 Routing Manual! HELP!
I stumbled on myigetit.com, but wasn't sure how good they were. I think I will buy one of their bundles since it comes recommended.
Thanks very much guys! Great Help!
RE: Solidworks 2008 Routing Manual! HELP!
www.SolidProfessor.com is also an excellent source for tutorials; very similar to i.get.it
RE: Solidworks 2008 Routing Manual! HELP!
Yes, because generally instructors cover many best practices that are not covered in the manual or the help.
In routing there are few things like constrain to sketch, placement mates and using drag and drop effectively that are quite important.
Good luck!
RE: Solidworks 2008 Routing Manual! HELP!
http://www.swcontractor.co.uk