non-planar o-ring groove
non-planar o-ring groove
(OP)
I'm still in SW2007. I want to create a groove for an o-ring on a 3D contoured part. This groove will go around a hole for a vacuum. It's almost like I want to do a 3D revolve, which isn't possible as far as I can tell.
Any ideas for this one?
-Matt
Any ideas for this one?
-Matt






RE: non-planar o-ring groove
(I wish I could edit my posts rather than replying to myself.)
RE: non-planar o-ring groove
RE: non-planar o-ring groove
RE: non-planar o-ring groove
You know, there wouldn't be much drama around here if everyone decided they could just answer their own questions all the time like that.
Jeff Mowry
www.industrialdesignhaus.com
What did you dream? It's all right--we told you what to dream.
--Pink Floyd, Welcome to the Machine
RE: non-planar o-ring groove
Dan
www.eltronresearch.com
RE: non-planar o-ring groove
Jeff Mowry
www.industrialdesignhaus.com
What did you dream? It's all right--we told you what to dream.
--Pink Floyd, Welcome to the Machine