Proper Etchant for Hot and Cold work steel
Proper Etchant for Hot and Cold work steel
(OP)
I have two samples that have been produced by extrusion(from powder). K190(X220CrVMO 13-4) and a steel that is H13.
I am looking for Proper etchant solution to see the carbides and also i want to reveal the matrix if it is Austenite or martensite?
Thanks for any kind of help.
I am looking for Proper etchant solution to see the carbides and also i want to reveal the matrix if it is Austenite or martensite?
Thanks for any kind of help.





RE: Proper Etchant for Hot and Cold work steel
http://ww
These are other good references:
http://www
http://www
http://www