Cant save
Cant save
(OP)
Hello everyone,
Im currently machining a large complex aerospace part, my problem is that when trying to save the part I get error message stating "out of memory". Its as if its a swap-space
problem because I just exit the part then restart and continue. Is there any way of increasing "swap space" within NX5?
Im currently machining a large complex aerospace part, my problem is that when trying to save the part I get error message stating "out of memory". Its as if its a swap-space
problem because I just exit the part then restart and continue. Is there any way of increasing "swap space" within NX5?





RE: Cant save
RE: Cant save
Best Regards
Hudson
RE: Cant save
The system memory is not being fully utilized when UG displays the "out of memory" warning and gives up. Seems to be an internal application limit. I don't have any solutions, nor am I certain about the system settings.
RE: Cant save
Now if you're running a 32-bit version of NX on a 64-bit system you can now get at the full 4GB of memory avialable to a 32-bit application (in a 32-bit system the OS takes the first GB or so, leaving only a maximum of 3GB for the applications such as NX, while on a 64-bit system the first 4GB is set aside for 32-bit applications since the OS if running up in the 64-bit memory space).
Of course if you install a 64-bit version of NX on a 64-bit system, there is no practical limit since NX can now access the full 64-bit of memory address-space, which is a VERY LARGE number indeed.
John R. Baker, P.E.
Product 'Evangelist'
NX Design
Siemens PLM Software Inc.
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
RE: Cant save
See if this works for XP users.
http://s
Hudson
RE: Cant save
Many thanks , its good to find point of contact for practical advice.