Where's the BOM
Where's the BOM
(OP)
SW 2008 SP2.1
When I insert a BOM related to a assembly, it will show all the part numbers but only a few random descriptions. Earlier today I imported the same assembly into a drawing and added a bom, and everything looked like it suppost to. Now it will only give me a few random descriptions.
I removed the bom, and tried again, but this time there were no descriptions at all. What gives?
When I insert a BOM related to a assembly, it will show all the part numbers but only a few random descriptions. Earlier today I imported the same assembly into a drawing and added a bom, and everything looked like it suppost to. Now it will only give me a few random descriptions.
I removed the bom, and tried again, but this time there were no descriptions at all. What gives?






RE: Where's the BOM
I doulbe click a field, and naturaly it brings up a message. Hit OK, then I just click the rebuild button and there is my BOM Descriptions.
I also have to hit Rebuild when I bring in a part/assemlby for my contents to show in my title block. Before, (2007), I would bring in a part, and it would automatically change my set specifications.
I will never learn 2008
RE: Where's the BOM
htt
FAQ559-1194: How Do I install New drivers for my Video Card?
RE: Where's the BOM
RE: Where's the BOM
RE: Where's the BOM
I still have to "load" the assemlby after starting a bom. After I "load" the assemlby by double clicking the description field, it imports all the description data with correct fields.