How to take output of Max tool reach Z from Postprocessor
How to take output of Max tool reach Z from Postprocessor
(OP)
Hi
I have a question. how to find out Max Z travel in a program and output it in nc file automatically? So that the operator can set length for that tool.
I have a question. how to find out Max Z travel in a program and output it in nc file automatically? So that the operator can set length for that tool.





RE: How to take output of Max tool reach Z from Postprocessor
http://bbsnotes.ugs.com/
It seems to work OK
John Joyce
Tata Technologies iKS
1675 Larimer St.
Denver, CO
www.myigetit.com
RE: How to take output of Max tool reach Z from Postprocessor
After adding in to before motion, it is not giving any output...anything need to be modified in the proc...?
could you please explain how to go about it.
Thanks
RE: How to take output of Max tool reach Z from Postprocessor
There are 2 procedures. One goes in the before motion and the second goes at the end of program
John Joyce
Tata Technologies iKS
1675 Larimer St.
Denver, CO
www.myigetit.com
RE: How to take output of Max tool reach Z from Postprocessor