Bent 30 inch Riser
Bent 30 inch Riser
(OP)
Scholars,
I have a 30" Riser with a 300 series Flange at one end, basically it comprises of two lenghts of casing welded at the middle. The overall lenght being 65ft.The Riser appears to be bent somewhere along it's lenght. We've pulled a line (from the flange end) parallel to the riser down to the other end and taken measurements to determine where the bend is, but we would like to find a more accurate way to go about this process.
I have a 30" Riser with a 300 series Flange at one end, basically it comprises of two lenghts of casing welded at the middle. The overall lenght being 65ft.The Riser appears to be bent somewhere along it's lenght. We've pulled a line (from the flange end) parallel to the riser down to the other end and taken measurements to determine where the bend is, but we would like to find a more accurate way to go about this process.





RE: Bent 30 inch Riser
RE: Bent 30 inch Riser
we looked into that but the overall lenght (65ft.) was the problem.
RE: Bent 30 inch Riser
inspection.
RE: Bent 30 inch Riser