UG 36 (a)(1) analysis
UG 36 (a)(1) analysis
(OP)
Dear All
How do we run FEA in Compress to address reinforcment is adequate per UG 36 (a)(1) on tangential nozzle with bracings on it . No external nozzle loadings are given. Does the output "FE Nozzle" that is available in compress is enough to justify the reinforcement? or any other specific software is needed !!!Thanks to u all in advance.
How do we run FEA in Compress to address reinforcment is adequate per UG 36 (a)(1) on tangential nozzle with bracings on it . No external nozzle loadings are given. Does the output "FE Nozzle" that is available in compress is enough to justify the reinforcement? or any other specific software is needed !!!Thanks to u all in advance.





RE: UG 36 (a)(1) analysis
Read the last 4 paragraphs in this FAQ... http://www.codeware.com/support/faq/1080.html