edge flange
edge flange
(OP)
Hi all,
Can I add an extruded cut to an edge flange without losing the sheet metal features? I have effectively a C channel created by edge flanges on which I need to shave the width with a secondary cut.
Can I add an extruded cut to an edge flange without losing the sheet metal features? I have effectively a C channel created by edge flanges on which I need to shave the width with a secondary cut.






RE: edge flange
Dan
www.eltronresearch.com
RE: edge flange
Jeff Mirisola, CSWP
Certified DriveWorks AE
http://designsmarter.typepad.com/jeffs_blog
Dell M90, Core2 Duo
4GB RAM
Nvidia 3500M
RE: edge flange
RE: edge flange
One for the flat layout without the material reduction, and another in the folded state [u]with[/b] the width reduction.
RE: edge flange
But the model will not allow me to make any extruded cuts on edge bends.
RE: edge flange
Jeff Mirisola, CSWP
Certified DriveWorks AE
http://designsmarter.typepad.com/jeffs_blog
Dell M90, Core2 Duo
4GB RAM
Nvidia 3500M
RE: edge flange
RE: edge flange