Space between cooling tower cells
Space between cooling tower cells
(OP)
How do I determine the space between indepentant cooling tower cells? Is there a standarized space? What are the limiting factors? If there is not standardized space, how do i calculate it?
The following information describes the cooling tower in question.
7 independant cells
Cross Flow
Induced draft
PVC film fill
900 GPM TOTAL
136 MBTU/H TOTAL
Thank you all ahead of time for your help
The following information describes the cooling tower in question.
7 independant cells
Cross Flow
Induced draft
PVC film fill
900 GPM TOTAL
136 MBTU/H TOTAL
Thank you all ahead of time for your help





RE: Space between cooling tower cells
For BAC cooling towers this is available at http://www
For Evapco cooling towers this is available at http://www.evapco.com/lpt_engineering.asp and choose "equipment layout".
I am sure other manufacturers have their own publications.
RE: Space between cooling tower cells
3D cfd computer models may now simulate typical wind profiles and advise impact on tower re-entrainment.