Routing Question SW2007
Routing Question SW2007
(OP)
I am using solidworks 2007 / microsoft XP with the routing add-in.
Every time I create a route using a spline I get a bend radius error
at the beginning of the route. I have been spending hours trying to
correct these. Does anyone know how to correct these easily? I am
routing wires and using straight lines with the auto fillet just looks
too blocky.
Every time I create a route using a spline I get a bend radius error
at the beginning of the route. I have been spending hours trying to
correct these. Does anyone know how to correct these easily? I am
routing wires and using straight lines with the auto fillet just looks
too blocky.






RE: Routing Question SW2007
Dan
www.eltronresearch.com