edrawing
edrawing
(OP)
Hi:
When I use the measurement tool in eDrawing I can only get 2 decimal place x.xx. How can I change it to show 3 decimal place measurements
x.xxx?
My eDrawings are generated from Solidworks 2007.
Thanks.
When I use the measurement tool in eDrawing I can only get 2 decimal place x.xx. How can I change it to show 3 decimal place measurements
x.xxx?
My eDrawings are generated from Solidworks 2007.
Thanks.






RE: edrawing
If you change inches to centimeters you get 76.2cm. It only shows you the last number that is not a zero.
Regards,
Scott Baugh, CSWP![[pc2] pc2](https://www.tipmaster.com/images/pc2.gif)
FAQ731-376: Eng-Tips.com Forum Policieswww.scottjbaugh.com