postprocessing and shopdoc and..
postprocessing and shopdoc and..
(OP)
hi.
Is it possible to inquiry nc program group attributes via TCL?
or any other solution to the next problem:
i would like some general information into the shopdoc table, for example: roughing, or drilling 4 pieces of 6H7 holes etc. Bcos a program group contains more operations, it looks practical attaching comments to the program group..
Any help would be appreciated!
Is it possible to inquiry nc program group attributes via TCL?
or any other solution to the next problem:
i would like some general information into the shopdoc table, for example: roughing, or drilling 4 pieces of 6H7 holes etc. Bcos a program group contains more operations, it looks practical attaching comments to the program group..
Any help would be appreciated!
----
kukelyk




