I have a nozzle set through a shell with a full penetration groove weld and a fillet weld to cap it off (see UW-16.1(c). For my UW-16 calculation I have a throat size of .97" (a 1 3/8" fillet weld). How do I measure my throat for this joint? Section 9 has three different definitions of throat: actual, effective, and theoretical. Which one do I use?
Red Flag Submitted
Thank you for helping keep Eng-Tips Forums free from inappropriate posts. The Eng-Tips staff will check this out and take appropriate action.
Reply To This Thread
Posting in the Eng-Tips forums is a member-only feature.
A number of terms like “digitization”, “digital twin”, and “digital thread” have started to emerge in the product design world. While these terms have loose and varying definitions, the core ideas that underpin each of these concepts are becoming increasingly important to successful product development. Download Now
Over the past few years, there has been growing interest among industrial companies and solutions providers with regards to Product Innovation Platforms, where design, manufacturing and IoT tools are bundled into a single software package. Download Now