Edit mass scaling
Edit mass scaling
(OP)
Hallo friends
could someone help me out on this matter,
in my STEP; dynamic explicit with ABAQUS/CAE, i have problem filling out the following underneath menus:
TYPE;
Feed rate :
Extruded element lenght:
Nodes in cross-section :
FREQUENCY;
SCALE every:
At :
what is the meaning of Extruded element lenght and Nodes in cross-section .
thanks in advance
anyasodor gerald
could someone help me out on this matter,
in my STEP; dynamic explicit with ABAQUS/CAE, i have problem filling out the following underneath menus:
TYPE;
Feed rate :
Extruded element lenght:
Nodes in cross-section :
FREQUENCY;
SCALE every:
At :
what is the meaning of Extruded element lenght and Nodes in cross-section .
thanks in advance
anyasodor gerald





RE: Edit mass scaling
See the ABAQUS users manual section 11.7.1 'Mass Scaling'.
Martin Stokes CEng MIMechE