Unwrap a curve mesh surface
Unwrap a curve mesh surface
(OP)
Hey guys,
I remember a basic surface unwrap functionality in old UG V18. I cant seem to find it in NX2 or NX4. If it is still available can someone point me to the right area?
I want to unwrap a curve mesh surface onto a plane. I saw if I had a cone or cylinder there was a function but I cant find the old one for this type of surface.
Thanks!!
GG
I remember a basic surface unwrap functionality in old UG V18. I cant seem to find it in NX2 or NX4. If it is still available can someone point me to the right area?
I want to unwrap a curve mesh surface onto a plane. I saw if I had a cone or cylinder there was a function but I cant find the old one for this type of surface.
Thanks!!
GG





RE: Unwrap a curve mesh surface
We've also got a new specialize application specifially for laying out composites.
John R. Baker, P.E.
Product 'Evangelist'
NX Product Line
SIEMENS PLM Software Inc.
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
RE: Unwrap a curve mesh surface
GG
RE: Unwrap a curve mesh surface
Is this new application at all related to the old composites application? Or is it something fresh (and supported)?
RE: Unwrap a curve mesh surface
The Composite Module is somewhat newer, being introduced with NX 1.0 back in 2002.
John R. Baker, P.E.
Product 'Evangelist'
NX Product Line
SIEMENS PLM Software Inc.
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
RE: Unwrap a curve mesh surface