toolbar customisation
toolbar customisation
(OP)
how can i remove the separators from my toolbars...i'm hoping it will help stop them switching shape.
I run 2 monitors, and have all the toolbars over on the RHS, i prefer to stretch all the toolbars as long as they'll go, but when i swap between modelling and drafting, they re-set their shape to suit themselves.
This is NX3, i remember finding it in customisation once before, and it seemed to help, but i think it may have been in a previous release (or maybe it was NX4 )
I run 2 monitors, and have all the toolbars over on the RHS, i prefer to stretch all the toolbars as long as they'll go, but when i swap between modelling and drafting, they re-set their shape to suit themselves.
This is NX3, i remember finding it in customisation once before, and it seemed to help, but i think it may have been in a previous release (or maybe it was NX4 )





RE: toolbar customisation
John R. Baker, P.E.
Product 'Evangelist'
NX Product Line
SIEMENS PLM Software Inc.
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
RE: toolbar customisation