Pultruded Carbon Tube
Pultruded Carbon Tube
(OP)
This request is very similar to thread327-83694: Pultruded graphite tube.
I am currently working on a design that requires carbon rod roughly 1.5" OD and .25" wall thickness. The lengths are around 8'. Any suggestions on manufacturers that would have this in stock and roughly how much it would cost?
Also, does anybody know of an off the shelf system for joining rods in various angles at least down to 15 degree increments? Thank you.
Rob Stupplebeen
I am currently working on a design that requires carbon rod roughly 1.5" OD and .25" wall thickness. The lengths are around 8'. Any suggestions on manufacturers that would have this in stock and roughly how much it would cost?
Also, does anybody know of an off the shelf system for joining rods in various angles at least down to 15 degree increments? Thank you.
Rob Stupplebeen





RE: Pultruded Carbon Tube
Rob Stupplebeen
RE: Pultruded Carbon Tube