HEC RAS Bridge Pier Geometry
HEC RAS Bridge Pier Geometry
(OP)
Hello all. I am trying to model a bridge in HEC RAS and in the pier data editor it allows me to enter pier width and elevation. Is there any way to change the shape of a pier? My piers are round not square. Is there a way to specify the shape to ensure I am entering the correct shape? Thanks!





RE: HEC RAS Bridge Pier Geometry
http://www.engr.udayton.edu/Civil/CEE%20584/Chapter%2010%20-%20Bridge%20Modeling%20and%20Analysis.pdf