Jet Turbine
Jet Turbine
(OP)
hi.
im modelling a jet turbine engine.its very nearly completed apart from a few minor niggles, which i cant seem to do.On the combustion i have a sheet metal rectangle with several rows of round holes in it, this is then rolled in to a cylinder which is fine, but i need the holes to be dimpled from the inside. can this be done? as i cant seem to do it. ant help appreciated
im modelling a jet turbine engine.its very nearly completed apart from a few minor niggles, which i cant seem to do.On the combustion i have a sheet metal rectangle with several rows of round holes in it, this is then rolled in to a cylinder which is fine, but i need the holes to be dimpled from the inside. can this be done? as i cant seem to do it. ant help appreciated






RE: Jet Turbine
"Art without engineering is dreaming; Engineering without art is calculating."
Have you read FAQ731-376: Eng-Tips.com Forum Policies to make the best use of Eng-Tips Forums?
RE: Jet Turbine
RE: Jet Turbine
Anyway, I had the same problem. Couldn't get dimples around the holes in the combustor can, at least not using the sheet metal features. I spent almost as long on that one problem as creating the rest of the engine.
Steve R.
RE: Jet Turbine
Please post a picture link when you're finished. I would love to see it.