How to make a compound angle in Solidworks?
How to make a compound angle in Solidworks?
(OP)
I need to make a trapezoid with a compound angle. I can easily draw/create it with the front or side views but cannot figure out how to do it 3D. Any suggestions?






RE: How to make a compound angle in Solidworks?
RE: How to make a compound angle in Solidworks?
Tom
Tom Malinski
http://www.okayind.com/
Dell Prec 670, Xeon 3.8,2GB Ram, Nvidia Quadra FX 3450/4000 SDI
SWorks Pro & PDMWorks 2007 SP3.0
RE: How to make a compound angle in Solidworks?
RE: How to make a compound angle in Solidworks?