How to pattern a feature in one direction
How to pattern a feature in one direction
(OP)
I am trying to pattern an extruded cut. I am trying to use the rectangular instance, but the XC and YC planes are not in the correct direction that I want to pattern my feature. Any ideas?????
Thanks
Thanks





RE: How to pattern a feature in one direction
Tim Flater
Senior Designer
Enkei America, Inc.
www.enkei.com
Some people are like slinkies....they don't really have a purpose, but they still bring a smile to your face when you push them down the stairs.
RE: How to pattern a feature in one direction
RE: How to pattern a feature in one direction
RE: How to pattern a feature in one direction
RE: How to pattern a feature in one direction
This sort of thing gets MUCH better in NX5 with the introduction of Instance Geometry.
Tim Flater
Senior Designer
Enkei America, Inc.
www.enkei.com
Some people are like slinkies....they don't really have a purpose, but they still bring a smile to your face when you push them down the stairs.