Using a spline in a drawing
Using a spline in a drawing
(OP)
I am trying to show a sketch of some wires coming out of our part in a drawing. I don't want to model the wires in the part. I'm using the spline command on the drawing toolbar. When i draw the spline it looks fine in SW, but when i print or even print preview the spline changes to jagged lines. Anyone have any ideas?






RE: Using a spline in a drawing
Use lines and arcs instead of a spline or
Check the quality settings in the Tools > Options.
RE: Using a spline in a drawing
Jeff Mowry
www.industrialdesignhaus.com
Reason trumps all. And awe transcends reason.