Faro Laser Scan Arm Calibration Problems
Faro Laser Scan Arm Calibration Problems
(OP)
My company recently purchased one of Faro's Laser Scan Arms. Unfortunately, I have had no luck getting it to calibrate. One of my collegues has gotten it calibrated on a few occasions, but that was after many tries and we can't figure out how the successful iteration was any different than the previous. We are using Faro's plate method and the only help Faro has offered is to mount the plate on a heavy stone to reduce vibration. Still no luck.
There was a pevious thread regarding this issue, but has since closed (thread87-131332: Anyone else using Faro’s new Laser Scanner?). Though the users on that thread eventually had success, there was no explanation of the methods that proved successful. Therefore, if somebody from that post (Accessory Guy or ReverseDog) or anybody else with experience could lend a hand, I would really appreciate it.
Thanks,
Greg
There was a pevious thread regarding this issue, but has since closed (thread87-131332: Anyone else using Faro’s new Laser Scanner?). Though the users on that thread eventually had success, there was no explanation of the methods that proved successful. Therefore, if somebody from that post (Accessory Guy or ReverseDog) or anybody else with experience could lend a hand, I would really appreciate it.
Thanks,
Greg





RE: Faro Laser Scan Arm Calibration Problems
Does anyone know of a FARO operator looking for work? We've got a third party to program it, all they need to do is operate.