dimension snap in nx4?
dimension snap in nx4?
(OP)
Hi,
In drafting, the dimension tent to align or snap to the previous dimensions. It is helpful. But sometime I do not want to. I try to locate the dimension very close to the previous one. I can not do it. Is there a way to turn it off. Thanks
In drafting, the dimension tent to align or snap to the previous dimensions. It is helpful. But sometime I do not want to. I try to locate the dimension very close to the previous one. I can not do it. Is there a way to turn it off. Thanks





RE: dimension snap in nx4?
RE: dimension snap in nx4?
regards ....
RE: dimension snap in nx4?