Mesh problem
Mesh problem
(OP)
Hi all.
Co-worker has not used his SW in about a year, and has SW 2005 SP 0.0.
He is testing a part, all goes well, however, when he tries to mesh the part, he gets the message " Mesh Not Created" and prompts him to click OK. He clicks OK, the graphics goes back to where he started before he tried the mesh.
Ive check - -no answer.
Can anyone advise?
Co-worker has not used his SW in about a year, and has SW 2005 SP 0.0.
He is testing a part, all goes well, however, when he tries to mesh the part, he gets the message " Mesh Not Created" and prompts him to click OK. He clicks OK, the graphics goes back to where he started before he tried the mesh.
Ive check - -no answer.
Can anyone advise?
Thanks,
Rip
SolidWorks 2007
SP 4.0






RE: Mesh problem
start over the entire CosmosWorks study (you can create a new studyt and then copy-paste the boundary conditions you had already defined in the previous study, if any). It frequently helps whenever for some reason the CW database is "mis-synchronized" with the SW one.
Regards
RE: Mesh problem
I really appreciate the advice.
Thanks,
Rip
SolidWorks 2007
SP 4.0