Is Top Nozzle for WRC Possible
Is Top Nozzle for WRC Possible
(OP)
I am currently trying to input a nozzle to a vessel at the top/head of the vessel which is of coarse has the same centerline. Is it still possible to model this without any errors?





RE: Is Top Nozzle for WRC Possible
This issue was covered by a recent thread in the Coade forum.
RE: Is Top Nozzle for WRC Possible
COADE Discussion Forum
Richard Ay
COADE, Inc.
RE: Is Top Nozzle for WRC Possible
Thanks,
Davis
RE: Is Top Nozzle for WRC Possible
Thanks,
Davis
RE: Is Top Nozzle for WRC Possible
http://www.coade.com/support_reference.asp?varflag=Reference#4
Richard Ay
COADE, Inc.
RE: Is Top Nozzle for WRC Possible
This Eng-Tips thread may also interest you:
thread378-189629: Basics of pipe stress analysis
Regards, John.