Part (Model) to Drawing (Orthographic) file
Part (Model) to Drawing (Orthographic) file
(OP)
I am new using Catia V5, so my question is how to bring up a model in a (Drawing) file. NOTE: I have set up my sheet, but I haven't found a clear way to transfer my model to the current DRAFTING (Drawing) file.
Thanks in advance.
Thanks in advance.





RE: Part (Model) to Drawing (Orthographic) file
Did you search first the forum or the FAQ area?
Regards
Fernando
RE: Part (Model) to Drawing (Orthographic) file
Thanks.
RE: Part (Model) to Drawing (Orthographic) file
use view creation wizzard to define view layout. pick face or plane that is to be the front.
RE: Part (Model) to Drawing (Orthographic) file
RE: Part (Model) to Drawing (Orthographic) file
Ken