Autoballooning Error Help
Autoballooning Error Help
(OP)
I get the following error when trying to autoballoon an isometric view from my BOM.
The following error occurred during update:
Internal Error
While updating object of type Parts List in 501287.prt
i then click ok, the only option, and get this message
Error recovery completed for the following error:
Internal error
The error message was not much help to me...wondering if anyone has come across this. Any advice at all would be appreciated.
The following error occurred during update:
Internal Error
While updating object of type Parts List in 501287.prt
i then click ok, the only option, and get this message
Error recovery completed for the following error:
Internal error
The error message was not much help to me...wondering if anyone has come across this. Any advice at all would be appreciated.





RE: Autoballooning Error Help
John R. Baker, P.E.
Product 'Evangelist'
UGS NX Product Line
SIEMENS
UGS PLM Software
Cypress, CA
http://www.siemens.com/ugs
http://www.plmworld.org/museum/
RE: Autoballooning Error Help
RE: Autoballooning Error Help
If you're in the US or Canada, call the toll-free support number: 1-800-955-0000
If you're outside of North America, contact your local Siemens UGS office or if you purchased NX from a supplier, contact them for help in how you forward problems for resolution.
To get more information on the services available and how to go about getting support go to:
htt
John R. Baker, P.E.
Product 'Evangelist'
UGS NX Product Line
SIEMENS
UGS PLM Software
Cypress, CA
http://www.siemens.com/ugs
http://www.plmworld.org/museum/