AS 1210
AS 1210
(OP)
People,
I want to know what is the minimum thickness of a 10" gas scrubber fabricated from A240-316/316L SS based on AS 1210.
Rgds Brighton
I want to know what is the minimum thickness of a 10" gas scrubber fabricated from A240-316/316L SS based on AS 1210.
Rgds Brighton





RE: AS 1210
In any case you didn't give enough information for anyone holding a copy to give you a solution.
RE: AS 1210
Rgds D.M
RE: AS 1210
htt
It will cost you US$57.
How does that compare to your hourly rate ?
RE: AS 1210
Geoffrey D Stone FIMechE C.Eng;FIEAust CP Eng
www.waterhammer.bigblog.com.au
RE: AS 1210
I want to work out the shell thickness of a vessel as per AS 1210 but I am unable to find a formula for minimum required thickness. Could anyone tell me what is the formula to work this out? Secondly, the process data is as follows:
Design pressure: 150 Barg
Material: Plate A240 316/316L SS
OD: 273 mm
Temperature: Ambient
Media: CO2
Rgds Diego