Runtime Error
Runtime Error
(OP)
Good Morning Folks,
I'm getting a runtime error when I select "Set Lightweight to Resolve" on an assembly with 21 parts.

I can't seem to figure out what's wrong. SW automatically restarts and have the same error again when trying to excute the same step. I rebooted the computer as well and the same error happens again. I clean all my temp and sw back-ups files on a regular basis. Kinda weird....
I'm getting a runtime error when I select "Set Lightweight to Resolve" on an assembly with 21 parts.

I can't seem to figure out what's wrong. SW automatically restarts and have the same error again when trying to excute the same step. I rebooted the computer as well and the same error happens again. I clean all my temp and sw back-ups files on a regular basis. Kinda weird....
Macduff ![[spin] spin](https://www.tipmaster.com/images/spin.gif)
Colin Fitzpatrick
Mechanical Design Engineer
Solidworks 2007 SP 4.0
Dell 390 XP Pro SP 2
Intel 2 Duo Core, 2GB RAM
nVida Quadro FX 3450 512 MB






RE: Runtime Error
FAQ559-507: Alternative to try before reinstalling
RE: Runtime Error
Have a good holiday sir.
Macduff![[spin] spin](https://www.tipmaster.com/images/spin.gif)
Colin Fitzpatrick
Mechanical Design Engineer
Solidworks 2007 SP 4.0
Dell 390 XP Pro SP 2
Intel 2 Duo Core, 2GB RAM
nVida Quadro FX 3450 512 MB
RE: Runtime Error
Macduff![[spin] spin](https://www.tipmaster.com/images/spin.gif)
Colin Fitzpatrick
Mechanical Design Engineer
Solidworks 2007 SP 4.0
Dell 390 XP Pro SP 2
Intel 2 Duo Core, 2GB RAM
nVida Quadro FX 3450 512 MB
RE: Runtime Error