SHEET METAL QUESTION
SHEET METAL QUESTION
(OP)
I am trying to create tabs on a piece of sheet metal that will be used to hold a piece in place during welding. I am trying to place these tabs on a radius as shown in the picture below. I do not know how I can create these and have them show up on the flat pattern. Could anyone tell me if this is possible.
http ://www.moo load.com/n ew/file.ph p?file=fil e01/020707 /118338466 3/flange.J PG&s=t
Brian
http
Brian






RE: SHEET METAL QUESTION
Your file doesn't seem to be working. Can you upload it again?
Jeff Mirisola, CSWP
CAD Administrator
SW '07 SP2.0, Dell M90, Intel 2 Duo Core, 2GB RAM, nVidia 2500M
http://designsmarter.typepad.com/jeffs_blog
RE: SHEET METAL QUESTION
Here we go again
http
RE: SHEET METAL QUESTION
Jeff Mirisola, CSWP
CAD Administrator
SW '07 SP2.0, Dell M90, Intel 2 Duo Core, 2GB RAM, nVidia 2500M
http://designsmarter.typepad.com/jeffs_blog
RE: SHEET METAL QUESTION
http://m1.freeshare.us/155fs583127.jpg
RE: SHEET METAL QUESTION
Create a tab on the top surface of the flat part.
Insert an "Fold" feature.
RE: SHEET METAL QUESTION
Thanks I can not believe that I could not remember how to do that. It has been awhile sense I last worked on some sheet metal. A star for you.
Brian