Flat pattern in IV 2008
Flat pattern in IV 2008
(OP)
Hello sheet metal specialists! Here is one very simple part that I'm designing: ht tp://img40 9.imagesha ck.us/my.p hp?image=l oftnm6.jpg and a "very simple" problem I'm having is - how to make flat pattern from it? I have experimented unsuccessfully different ways. Is it still the same jam in IV 2008 like it has been before (you have to construct parts like this without bends)!?





RE: Flat pattern in IV 2008
RE: Flat pattern in IV 2008
as I know generally cylindrical and conical surfaces can be unfolded only.
RE: Flat pattern in IV 2008
RE: Flat pattern in IV 2008
Its just hard to imagine IV not being able to unfold that part. It doesn't look that hard.
RE: Flat pattern in IV 2008
Autodesk really have a long way to go with the unfolding abilities of Inventor. Square-to-rounds, offset-cones etc is really beyond it, and I think it'll be a few releases yet to get to where it needs to be.
RE: Flat pattern in IV 2008
RE: Flat pattern in IV 2008
htt