NX4 DRAFTING:
NX4 DRAFTING:
(OP)
Hello All,
Great one, this. I have a large plate with 121 holes in circular array. Attempting to put a Full Bolt Circle Utility Symbol on this array, the function maxes out at 100 centerlines. Pop-up error message says: Maximum number of associated objects for the centerline has been reached."
Is there a way to increase the number of centerlines this function will create?
Thanks,
'ziner
Great one, this. I have a large plate with 121 holes in circular array. Attempting to put a Full Bolt Circle Utility Symbol on this array, the function maxes out at 100 centerlines. Pop-up error message says: Maximum number of associated objects for the centerline has been reached."
Is there a way to increase the number of centerlines this function will create?
Thanks,
'ziner





RE: NX4 DRAFTING:
John R. Baker, P.E.
Product 'Evangelist'
UGS NX Product Line
SIEMENS
UGS PLM Software
Cypress, CA
http://www.siemens.com/ugs
http://www.plmworld.org/museum/
RE: NX4 DRAFTING:
Thanks again,
'ziner
Peace Through Superior Fire-Power!
RE: NX4 DRAFTING:
1. I can get a full bolt circle of 121 holes by using 2 partial bolt circles; BUT,
2. To get a partial bolt circle with a partial circle line, pick the hole centers in counter clockwise order.
3. For a partial bolt circle, if you pick the hole centers in clockwise order you will get the full circle line.
'ziner
Peace Through Superior Fire-Power!